Speed mod`s database 300x/lx

[elpeladodelsamba]

PLEASE POST SPEED AND MODS OF ANY 300X/LX SO WE DON`T HAVE LO LOOK THEM ALL OVER POSTS !!
I WILL START WITH MINE. STOCK 300X GREEN 67.5MPH . THICK WASHERS ON 73MPH FOR ABOUT 15-20 SEC 8000RPM AND THEN COMING BACK TO 7600RPM 67.5 MPH .

[elpeladodelsamba]

Are you getting the Riva override? 74 is pretty impressive, was that with <1/4 tank of fuel? How many hours on the ski?

full tank washer mod. 15degrees celcius. flat water

[Olomana]

Speed: 71MPH GPS
Test Pilot: 94KG
Fuel: 3/4
Temp: 26-27C
Humidity: 80%
Condition: low chop, low wind.
Modification: Stock 300X with Dustin module. No rear seat, No front bucket with ECU cover removed.

Keep in mind, before removing everything for fresh air, the ski was going only around 69MPH GPS!
In a hot and humid country, it makes big gain!

[nicjak]

cant see the use of a data base when you go and remove everything for a once off run doesnt make sense to me, we all know it will go faster if you start and pull shit off it, shit why dont you just pull the hood off next time and both seats and the tray shit why stop there just put 1ltr of fuel in it and empty the glove compartment. btw how do you get more fresh air with the front bucket removed as it seals to the hood anyway.

[Olomana]

First I do ride it that way everyday when staying in the lagoon.
Second when you remove the front bucket, it doesn't seal anymore the storage area.
It will allow more fresh air to get in even without having a air duct.

If it went from 69 to 71, that mean it must work no?

[Blue 182]

71 is a great speed Olomana! But, you are compromising water seal. I would not remove ECU compartment cover or bucket ever. I get too much water over bow. Plus, I have plenty of cold air here. Too much actually. Id mail you some if I could. 78 deg.water, 85 deg. air, calm turquoise water as far as eye can see...and a new 300X...sweet Olo!

[Olomana]

71 is a great speed Olomana! But, you are compromising water seal. I would not remove ECU compartment cover or bucket ever. I get too much water over bow. Plus, I have plenty of cold air here. Too much actually. Id mail you some if I could. 78 deg.water, 85 deg. air, calm turquoise water as far as eye can see...and a new 300X...sweet Olo!

So far even with the bucket of, I do not have much water, or no water at all since i'm riding in the lagoon where it is pretty flat.
I'm going to cover the whole hole with a pre filter sheet for more insurance.
And I already treated the ECU just in case salt water was going into it.

But as soon I know I go out of the lagoon, I put everything back since top speed is not my main concern.

Thanks!

[KawaHead]

PLEASE POST SPEED AND MODS OF ANY 300X/LX SO WE DON`T HAVE LO LOOK THEM ALL OVER POSTS !!
I WILL START WITH MINE. STOCK 300X GREEN 67.5MPH . THICK WASHERS ON 74MPH FOR ABOUT 15-20 SEC 8000RPM AND THEN COMING BACK TO 7600RPM 67.5 MPH .

Did you manage to find the problem for the drop after 15-20 seconds ? Can it be rectified ?

[elpeladodelsamba]

Did you manage to find the problem for the drop after 15-20 seconds ? Can it be rectified ?

no. i am waiting the riva speed control override module to do so!! other than that cant figure out how.

[lasportsmn]

Did you manage to find the problem for the drop after 15-20 seconds ? Can it be rectified ?

no. i am waiting the riva speed control override module to do so!! other than that cant figure out how.

Kawa- mine was doing the same but wasn't taking that long to drop. Mine was doing it afrer a couple seconds. I installed the Riva Bypass Module and have not had a problem since.

[elpeladodelsamba]

Kawa- mine was doing the same but wasn't taking that long to drop. Mine was doing it afrer a couple seconds. I installed the Riva Bypass Module and have not had a problem since.

gustav mine was doing like 10 sec for shure. i dont time it but seemed a lot of time. i installed reallyy thick washers maybe that`s why. could be lots of factors. i still think with speed bypass will run consistent 73 miles at least. when i install the bypass i will film it with gps shown . so that the non belivers start having faith on 300 lol.
take care , juan francisco

[c6racer]

20Cair, 13Cwater, calm/breeze, 85kgpilot, 1/4tank = 8150/8200rpm and 75mph.
Bypass, 4"air, plate, intake and other stock legal mods.

[Olomana]

20Cair, 13Cwater, calm/breeze, 85kgpilot, 1/4tank = 8150/8200rpm and 75mph.
Bypass, 4"air, plate, intake and other stock legal mods.

Don't mind listing the brand?
Did you loose any hookup in rough?

Thanks

[c6racer]

Don't mind listing the brand?
Did you loose any hookup in rough?

Thanks

RIVA bypass, TBM plate and grate, other stuff is own shop-made.

Ruff... tuff to say, of course you are going to loose it sooner or later...

[Hammy]

RIVA bypass, TBM plate and grate, other stuff is own shop-made.

Ruff... tuff to say, of course you are going to loose it sooner or later...

@OLO : See I told you...go for the TBM rideplate :P