Tweet
I'm not a big fan of the curved grips used on the kawi. So I changed them out to ODI Rogue grips.
I had to cut the bar ends off. If you are looking to replace the bar, be advised that it is a standup-style bar. The grips are vulcanized rubber, so a razor works. You can heat them, or just peel them off. The switch housing and throttle are screwed on. The cover is screwed on, then captured on a back piece. The buzzer goes inside the foam.
I had to cut the bar ends off. If you are looking to replace the bar, be advised that it is a standup-style bar. The grips are vulcanized rubber, so a razor works. You can heat them, or just peel them off. The switch housing and throttle are screwed on. The cover is screwed on, then captured on a back piece. The buzzer goes inside the foam.
Attached Files
Comment