Intake Manifold Split.... Can it be fixed?

[GTLaser]

So I found where I was leaking boost once the manifold completely opened up under the ECU.... I noticed it is a very thin adhesive being used. Can I just reseal it using an PC-7 type material or is it recommended to just replace the whole thing? Again thanks for everyone's help!

[breon]

most likely you will have to replace it..

i have one i will sell you... it has been bolted and epoxied ..for lowe vol fo quicker response..that is what most of the big turbo skis do ..you can see it in my build thread..i went to the apc manifold. so i no longer need it..

[GTLaser]

most likely you will have to replace it..

i have one i will sell you... it has been bolted and epoxied ..for lowe vol fo quicker response..that is what most of the big turbo skis do ..you can see it in my build thread..i went to the apc manifold. so i no longer need it..

Will it match up with my 2Rude, Rotax ECU and your exhaust set up I have? I am also going back to stock pump as I want more MPH.... my skat right now is major hole shot, would it work well with that as well? Thanks!

[breon]

yes it is a stock manifold ..we just driil the flanges and bolt the two halves together..then poor epoxie inside..help bond and seal and reduces the volume in the intake for better throddle response..

just pm me if you want it..