Tweet
any one have any thoughts on how to mount a 06 cluster in a 05 hood.thanx
-
-
never mind got it figured out.thanx -
How did you end up doing it? I have a similar issue.2006/2006 GPRXP - 2008 electronics, Hull trued, Leo's holeshot kit, Stock SC w. Greenwheel, Type 9 IC, 42lb injectors, Skat 14 vein pump, 14/23 Dynafly, cut R&D tabs, Jetworks pressure relief on pump, stock Riva plate with stock angle (no shims), carbon fiber hood, R&D sponsons, UMI steering system with Protaper bars, R&D exit nozzle, R&D extended steering nozzle.
COULD NEVER HAVE DONE THIS WITHOUT THE HELP OF GREENHULK! Thank you everyone!Comment
-
i put the 06 cluster up inside and took a marker and mark where the holes were.the holes are very close to the edge.drilled the holes put the same screws with a small washer and tighten it up.i found that i was off to one side.my bezel would not just snap on so i cut some of the hood away with a olfa knife.Comment
Comment