XS Kit Installation Instructions

[SinWolf]

Good day...

Will the XS model fit my 2010 RXP-X 260 RS ??

Theres a couple of different options in the store, and I'm not 100% sure which of those are compatible.

I have no mods on my ski.

Thanks

[Davrac]

Think I need one of these for my GTR.

[wolf513]

I just elected to remove it for now. Maybe I'll trim it shorter later on.

[JFizzleJR]

I was not aware of that. I think we don't hear of it because most people remove that duct. I would suggest doing the same, or at least cut it shorter if you want to keep it installed.

The stock rear air duct hits on the IC pipe from the supercharger.

[wolf513]

The stock rear air duct hits on the IC pipe from the supercharger.

[JFizzleJR]

Can you post a picture?

I am in the process of installing this in my 04 RXP. I am having a problem getting the rear air intake duct to fit back in place.

Do I need to remove or shorten the rear air intake or is my placement of the IC off?

[wolf513]

I am in the process of installing this in my 04 RXP. I am having a problem getting the rear air intake duct to fit back in place.

Do I need to remove or shorten the rear air intake or is my placement of the IC off?

[JFizzleJR]

James emailed me the new instructions. This addresses the newer design bracket.

Thank you. I just updated the first post.

[sHALlow]

Updated instructions

James emailed me the new instructions. This addresses the newer design bracket.

[David_HX_RXP]

Can I get a phone number to call (I/C manufacturer) ?

I have more questions about the specs of this unit than I want to go back and forth with in a thread.

david

[TrianoRaceCo]

OK thanks James. Its a lot easier than I thought then.

[JFizzleJR]

Barry, it does not make a difference if you route the transom hose and exhaust hose to the front or back. I put the transom hose into the front and splice the water strainer in the middle of that hose. Let me know if you have any other questions.

[TrianoRaceCo]

A few questions before i get started

I want to be sure with everything before I get started in about a month or so. Which end on the Fizzle Xs is the water inlet and outlet. Im assuming the hole closest to the front when mounted is the inlet? does it matter? Then also, when installing the strainer, can i just splice it in the line coming from the transom anywhere on the line?

If someone could just give me a routing diagram, ie. transom to front of IC, back of IC to exhaust manifold, or opposite. Would help a lot.

Thanks in ahead

[RightOnTarget1]

This is great! Thanks!

[JFizzleJR]

Jim,

I didn't forget about you. I checked into this but didn't get much of a result yet. I'll send you what I have so far. I can get whatever piping and couplings you need. 18" and 24" of all types of bends if what I have isn't sufficient. What I have found is the boats go pretty well with a 24" straight pipe (cut down to proper length depending on mount) and a 45" pipe.

Pressure Drop = Less than 0.1 PSI -- Inlet/Outlet = 3.0" -- IC = 12" x 12.25" x 4.5" -- Core Size = 10" x 4.5" x 4.5" Maximum pressure = 70 PSI

There is airflow provided by user "Danny" comparing all of the common intercoolers used on the 4-tec motors.

Feel free to PM me with any questions.