Riva oil catch can mounting 2011 RXTis 260

[gbest]

I tried mounting it to the end of the manifold as shown in the instructions but the air intake runner is in the way.
Another picture shows it on the other end but the bracket doesn't line up with anything there.
Where can I mount this thing in a suspension ski?

[notabot]

First, just find a spot where you can either zip tie it or use a SS hose clamp to secure it in an upright position. Second, make sure it's in a spot where you can see it and drain it by just taking the seat off. If you hide it, it could be tough to service.

[rtarford]

I tried mounting it to the end of the manifold as shown in the instructions but the air intake runner is in the way.
Another picture shows it on the other end but the bracket doesn't line up with anything there.
Where can I mount this thing in a suspension ski?

on my 13 RXTX AS , I got a stainless steel catch Can from green hulk that mounted to the front lift
point , I could not use the filter so I hooked an elbow and routed a hose back to the stern terminated with a gas vent , I put a loop in the hose to make sure I didn't get any water coming in , you just have to bend the bracket a little bit so the engine cover will go back on , to drain it I just use my oil extractor to suck it out from the top

[gbest]

Rtarford, Somehow I missed your post.
Do you have the part number for the vent handy?
I appreciate your pictures and explanation of the install.

[rtarford]

it was $114.95 GRF racing SS catch can , I bought it from GH . I can't find the actual part number though, and I went through a lot of receipts