FREE Tunnel Reinforcement Template DOWNLOAD !!

[bgruhn76]

Would you mind sending me the template? [email protected]

Thank you.

[drfong]

Just wondering how many layers of carbon fiber you used?

[RX951]

I recommend the West System Epoxy. Tommy Jordan from Fountain Racing turned me on to this. Rock hard after it dries and user friendly pumps on each can.

[RUNWME]

since they are on backorder now.. figured i would send this ttt

[RX951]

The Tunnel Templates have been compressed / resized to a much smaller file size for faster printing !!

Or, I can Email it to you !! Sometimes, emailing it works better
.
.
.

[RX951]

Paper template on the tunnel


My install pics below

http://www.hydrotoys.com/gpr/tuners/rx951/tunnel/

[RX951]

You can right click on each template and SAVE AS and download to your PC, then print

or

Click on the pic and print (may take a while due to image size)

or

I can e-mail the pics to you.

or

I can mail USPS to you.

[RX951]

Right Side Tunnel Template

Here is the RIGHT SIDE tunnel template for download and printing. It should print full size.

Click on picture, then print.

Cut on the solid lines under the dotted ones that outline the outer perimeter of the template.

The two internal lines are for folds that are needed around the pump tunnel.

Tape the top portions of both templates as the original picture ^above^ shows.

Or I can E-mail anyone the template now.

[RX951]

Left Side Tunnel Template

Here is the LEFT SIDE tunnel template for download and printing. It should print full size.

Click on picture, then print.

Cut on the solid lines under the dotted ones that outline the outer perimeter of the template.

The two internal lines are for folds that are needed around the pump tunnel.

Tape the top portions of both templates as the original picture ^above^ shows.

Or I can E-mail anyone the template now.

[carbuff91]

Bill,

Can you send one to [email protected]

Thanks,
Steve

[RX951]

Send me your address and I will mail or email out a tunnel reinforcement template.
This can be traced out for Fiberglass or Carbon Fiber like I did mine.

I have mailed out a dozen or so in the past few weeks, and all have turned out great for everyone !

Lemme know if anybody wants one.

The R&D carbon fiber peice is great !

But, if they are on backorder and
you don't want to wait and save money,
you can do this for less than $ 50.00 !

My install pics below
http://www.hydrotoys.com/gpr/tuners/rx951/tunnel/