Above Forum Ads

Collapse

Announcement

Collapse
No announcement yet.

2008 GP1300R Revved Down, Died

Collapse
X
 
  • Time
  • Show
Clear All
new posts

  • 2008 GP1300R Revved Down, Died

    Hey, all - first post here and new owner, so please bear with me.

    I recently acquired two GP1300R skis - '07 & '08 with low hours (76 and 72). Took them both out three times and everything ran fine.

    Took one out a fourth time and this happened: ran for 10 minutes in a light chop, so only at about 2/3 throttle. Suddenly the engine revved down (while holding throttle) and died. The engine fired right back up, then did the same thing - revved down and died. This happened 3 times before the battery died and I wasn't able to fire it back up.

    I walked (yes walked) the ski back to dock. Got it home and added oil - only took about 14oz - and charged the battery. Hooked the hose on the cooling intake and noticed the cap had been left off from the last ride, so that cap was off as I rode. Not sure if that's significant. Anyway, ran the water and the ski fired up fine. Ran for 5 minutes at idle with no issues. Throttled it a couple of times to 4k rpm and no issues. Any ideas?

    Thanks in advance!

  • #2
    Usually when that happens it’s an oil line issue. Make sure all your injection lines are hooked up.

    Comment


    • #3
      Originally posted by Jonesyfxr
      Usually when that happens it's an oil line issue. Make sure all your injection lines are hooked up.
      Would there have been oil in the engine compartment?

      Comment


      • #4
        That would depend of a line came completely off or just partially. Ours was just resting on the nipple and I caught it after a post ride inspection.

        Comment


        • #5
          Originally posted by Jonesyfxr
          That would depend of a line came completely off or just partially. Ours was just resting on the nipple and I caught it after a post ride inspection.
          ok - any photos? Trying to figure out where that is.

          Comment


          • #6
            Ours is a GP1200R. I know it’s hard to see the oil injection lines due to the pipe and the factory protective loom.

            Comment


            • #7
              Here’s a schematic:

              Shop online for OEM Injection Pump parts that fit your 2003 Yamaha GP1300R (GP1300B), search all our OEM Parts or call at (231)737-4542

              Comment


              • #8
                I dropped the ski in the water last night to test it and it ran fine. I added a little oil to the gas, so not sure if that's what did it. I'll keep this updated.

                Comment

                Working...
                X
                😀
                🥰
                🤢
                😎
                😡
                👍
                👎