Above Forum Ads

Collapse

Announcement

Collapse
No announcement yet.

GP1200 NPV Won't Start After Rebuild

Collapse
X
 
  • Filter
  • Time
  • Show
Clear All
new posts

  • GP1200 NPV Won't Start After Rebuild

    Hello. I have a pair of 1999 GP1200s that I bought about five years ago. When I got them, one had a cratered piston so I had to do a top end rebuildright off the bat. They've both been great runners since then with only what I consider normal maintenance type issues. But at the end of last year, the one my son rides took a dump. It would run, but it took some finessing to get it over ~30 mph. We were able to limp it to shore, and when I got it home I did a compression test. I found two cylinders with ~120 psig and one (the front) was completely dead. We were done for the year, so I winterized and parked them.

    About a month and a half ago, I pulled the engine, tore it apart, and this is what I found:

    Click image for larger version  Name:	2023-03-01 19.17.16 - Copy.jpg Views:	0 Size:	1.16 MB ID:	6155127‚Äč
    No smoking gun, but the front seal was a bit chunked up. I suspect it was drawing air causing the front cylinder to go lean. I was able to clean the cylinders up with a 1.0mm bore, and I got a top end kit from WSM. Everything went together smoothly, and I got a good pressure test first try. I got the engine back in and buttoned up yesterday.

    But, here's where I need help. The engine spins freely on the starter, but it doesn't even try to fire. I'm priming through the flame arrester ports with fresh premix so I know I've got fuel. I also have spark at all three plugs. I had originally put the old plugs in since I was concerned about fouling with all the assembly oil and 50:1 break in mix in the tank and an operational oiling system. I went ahead and swapped new plugs in and checked compression (all ~125 psig) while I was at it. Still nothing. I did get a backfire out the exhaust one time when I probably primed too much, but otherwise no fire at all.

    I have fuel, air, spark and compression, so the only thing left that I can think of is timing. The flywheel is keyed, so it's almost impossible to install that incorrectly. Is there something inside the mag cover that could have been damaged during removal or installation? I'm about out of ideas, so I'd like to hear your thoughts. Thanks in advance.
    2x 1999 Yamaha GP1200 WaveRunners
Working...
X