Need Help 2001 GP1200r Carb setting's for current mods

[[email protected]]

Recommended carb settings for the following installed mods. Riva Stage 2 minus the flame arrestors, Stinger 3 exhaust, vforce 3 reeds on stock head and pistons. I have the flame arrestors if you guys recommend I put them on. I'm having a hard time sourcing the correct Pilot jet, Main jet, Low and high speed turn-outs, needle seat, spring weight and avg. pop off info for the setup that I current have.

[Jonesyfxr]

Look at the Oside Bill stick on jetting with flame arrestors. We did this on our GPR and it was dead nuts out of the box. It's a sticky

[[email protected]]

Ty

[Jonesyfxr]

You're welcome.... you'll need to order jets, t handles, seats, adapters and filters but its totally worth it.

[[email protected]]

I am ordering the jets and t handles what are the adapters? Also I used Yamabond 4 to seal my case as the gasket maker, is this ok or should I have used something else?

[Jonesyfxr]

That will work, we used Permatex fuel resistant sealant. The adapters are for the flame arrestors. We bought a kit off eBay just for the GPR.

[Jonesyfxr]

Also… use only MIKUNI kits and get the needle and seats as well.

[[email protected]]

Will do ty for the advise ! Have a great day !

[Jonesyfxr]

No problem.... look at our build thread if you have questions.

[Jonesyfxr]

Here’s the flame arrestors

https://www.ebay.com/itm/223739710178?mkcid=16&mkevt=1&mkrid=711-127632-2357-0&ssspo=GMSSIVQFTQi&sssrc=2349624&ssuid=Azg_2zFjS_O&var=&widget_ver=artemis&media=COPY