23 Fx Svho Solas 13/18

[beaver6713]

The nice thing about the MaptunerX is there is a Stage 1 8000 RPM tune that cannot be detected by the dealer. Your ski is not going any faster until you reflash the ECU to remove the speed limiter. Later down the road when you are not concerned about engine warranty, use your MaptunerX to load an upgrade tune with a higher rev limiter. Tune upgrades cost you nothing with the MaptunerX system. This is the tuning bundle package that you need https://www.4-tecperformance.com/ind...oducts_id=4250

Also, concerning warranty. This is a good read

https://www.greenhulk.net/forum/personal-watercraft-performance-skis/yamaha-pwc-performance/yamaha-pwc-performance-4-stroke/262395-

Thank you sir. I have already purchased the maptunerx for my 2018 SVHO, I will purchase a credit for my 2023 as you suggest.

[Green Hulk]

If I re flash the ECU will that void my warranty?

The nice thing about the MaptunerX is there is a Stage 1 8000 RPM tune that cannot be detected by the dealer. Your ski is not going any faster until you reflash the ECU to remove the speed limiter. Later down the road when you are not concerned about engine warranty, use your MaptunerX to load an upgrade tune with a higher rev limiter. Tune upgrades cost you nothing with the MaptunerX system. This is the tuning bundle package that you need https://www.4-tecperformance.com/ind...oducts_id=4250

Also, concerning warranty. This is a good read

https://www.greenhulk.net/forum/personal-watercraft-performance-skis/yamaha-pwc-performance/yamaha-pwc-performance-4-stroke/262395-

[beaver6713]

If you reflash the ECU to to remove the speed limiter then the Solas impeller and the ride plate is a must have! All of these items are included in the stage 1 plus kit
FX SVHO STAGE 1 PLUS [RY-RPM-FXSVHO-1.5-22] : PWC Performance Parts (4-tecperformance.com)

If I re flash the ECU will that void my warranty?

[Green Hulk]

I believe the same plate fits the 2018 and older FX as well as the 2019+

Yes! It bolts up perfectly 👍

[Green Hulk]

I’ve been going over the Riva site looking for a ride plate for the 2018 FXSVHO. I’ve found the sponsons, however no the plate.

Can you point me in the right direction.
buy ya a beer.?.

You can buy Riva parts right here in the GreenHulk Store at discounted prices, use discount code “greenhulk” at checkout 👍

the 2019 and newer riva plate also fits the 2018 FX. There’s no provision for the Speedo paddle wheel sensor on the 2019+ riva plate, but no big deal as everyone runs the CandooPro GPS module anyway as the stock paddle wheel is hardly accurate

ride plate: discount code saves you $32.30 off retail price
https://www.4-tecperformance.com/index.php?main_page=product_info&cPath=350_94_292& products_id=6569

Sponsons: discount code saves you $51.60 off retail price
https://www.4-tecperformance.com/index.php?main_page=product_info&cPath=350_94_290& products_id=2605

[jolson]

I believe the same plate fits the 2018 and older FX as well as the 2019+

I think it’s 12-18 skis. Then 19+, they call out different. They just didn’t have a plate for 12-18 on their site that I found.

I guess I should send a note to Riva asking for surety.

Thank you.

[Mr. GP1800]

I’ve been going over the Riva site looking for a ride plate for the 2018 FXSVHO. I’ve found the sponsons, however no the plate.

Can you point me in the right direction.
buy ya a beer.?.

I believe the same plate fits the 2018 and older FX as well as the 2019+

[jolson]

The Riva ride plate is a must have on these skis. The stock plate is holding you back. You will see a speed gain with the Riva plate and much better handling and hookup.

I’ve been going over the Riva site looking for a ride plate for the 2018 FXSVHO. I’ve found the sponsons, however no the plate.

Can you point me in the right direction.
buy ya a beer.?.

[not2fast]

I bought all of these parts for my new 2023 limited. I may start installing them today. I bought the 13/20 impeller to keep the RPMs down a bit so I can stay under 8000.

I will be curious how you like the 13/20 and if you pick up any speed or acceleration. How is your FX's cavitation?

[Mr. GP1800]

If you reflash the ECU to to remove the speed limiter then the Solas impeller and the ride plate is a must have! All of these items are included in the stage 1 plus kit
FX SVHO STAGE 1 PLUS [RY-RPM-FXSVHO-1.5-22] : PWC Performance Parts (4-tecperformance.com)

I bought all of these parts for my new 2023 limited. I may start installing them today. I bought the 13/20 impeller to keep the RPMs down a bit so I can stay under 8000.

[Green Hulk]

I just got the 23 limited. Looks like I need to get a new ride plate. I am going to leave the impeller stock for now I think.

If you reflash the ECU to to remove the speed limiter then the Solas impeller and the ride plate is a must have! All of these items are included in the stage 1 plus kit
FX SVHO STAGE 1 PLUS [RY-RPM-FXSVHO-1.5-22] : PWC Performance Parts (4-tecperformance.com)

[beaver6713]

I just got the 23 limited. Looks like I need to get a new ride plate. I am going to leave the impeller stock for now I think.

[Green Hulk]

I just finished the mechanical install of a 2018 FXSVHO STABE 2, minus the seal kit on the bottom.

I have the upgraded intake grate. I’m gonna lift the ski on a friend lift to install the kit for the ride plate .

what’s the advantage of the ride plate. I tend to upgrade when opportune.

The Riva ride plate is a must have on these skis. The stock plate is holding you back. You will see a speed gain with the Riva plate and much better handling and hookup.

[jolson]

Use the discount code "greenhulk" in the forums store to save some $$$ on ride plate and intake grate.
The Solas impeller is also discounted in the GreenHulk store

I just finished the mechanical install of a 2018 FXSVHO STABE 2, minus the seal kit on the bottom.

I have the upgraded intake grate. I’m gonna lift the ski on a friend lift to install the kit for the ride plate .

what’s the advantage of the ride plate. I tend to upgrade when opportune.

[Green Hulk]

Thank you for such a quick response! Sounds great!

Use the discount code "greenhulk" in the forums store to save some $$$ on ride plate and intake grate.
The Solas impeller is also discounted in the GreenHulk store