steve45
Last Activity: Yesterday, 10:29 PM
Joined: 02-12-2008
Location: Texas
-
Don't know. If you have them, it shouldn't be hard to change them and see how they compare. -
Benny, have you ever thought about installing an electric bilge pump? It sure is a good thing to have if you have a cooling line spring a leak or if your driveshaft seal fails...Leave a comment:
-
Usually when you have a leak on the driveshaft bearing housing flange seal, or driveshaft holder as it is called, the rubber actually splits. To replace it, you have to remove...Leave a comment:
-
My mother used to say, "If you can't say something nice, don't say anything at all."
If you don't want to go through it yourself, send it to Impros....Leave a comment:
-
Of course not! When I get a renewal notice in the mail, I look at my spreadsheet to see what else is due for renewal that month so I can get everything done in one trip to the...Leave a comment:
-
Parts for those carbs are expensive, and some OEM parts are no longer available. I don't order parts for them until after I open them up and see what they really need. Usually,...Leave a comment:
-
Thank you!...Leave a comment:
-
Like this?
​...Leave a comment:
-
Another problem, when you open a thread, it goes to the first page, rather than the last page....Leave a comment:
-
So you own the trailer, but just haven't registered it for a long time. Hard to believe that your state doesn't have a record of it. What state are you in? Do you have to get...Leave a comment:
-
I finally fired up my Kawasaki Jet Mate in the shop today, first time I've heard it run. I put a pair of Proks on it only because the OEM airbox wouldn't fit (the single carb...Leave a comment:
-
Oh, yea, dump the orange bars under the avatar.Leave a comment:
-
Forum Changes
I don't know what's going on, but this is the third forum website that I participate in that have been revamped in the last few months. I can't see any improvement in the others,... -
Your 'Ski has two water drains in the hull. It's very common for trash to collect in the pickups and plug them. Look for the vertical black hoses on each side of the hull. There...Last edited by steve45; 03-19-2023, 10:22 PM.Leave a comment:
-
Radio Control Electric Ultra 150 On Ebay
1/5 scale! For the ridiculous price of only $ 1090!
https://www.ebay.com/itm/39451701076...AQAHAAAAwIqs1Z... -
So, you have TWO RXPs? One with a blown engine, the other has a beat up hull? It would be a helluva lot easier to put a SeaDoo engine into a SeaDoo hull, especially if it's the...Leave a comment:
-
Leave a comment:
-
You can take pictures with your phone and transfer them to your computer. Make sure you have good lighting. If you have Photoshop or other graphics programs you can convert...Leave a comment:
-
The fuel gauges on my older LXs and 310X come on too early IMO. Somewhere around 7 gallons remaining. I don't know how much unusable fuel remains when it runs out.
...Leave a comment:
-
That's a great idea! I've used a similar trick when installing jet pumps and when I replaced the cylinder head on my forklift, but never thought about it for cylinder blocks....Leave a comment:
No activity results to display
Leave a comment: