Yes, the pressure is checked and pressure regulator is at the return line, that way the entire system has steady pressure, including the injecters.
Pinch the return...
casey67
Last Activity: Yesterday, 09:00 PM
Joined: 09-09-2006
Location: Lemont,IL
-
in the cover, it pushes the bendix towards the back of the housing.Leave a comment:
-
There are very thin washers at the front and rear? of the bendix, did you mix them up ?
Are you using a gasket on the cover ? I've seen the cover being too close when just...Leave a comment:
-
Welcome to GreenHulk.
I don't think a picture would do you much good- with wires running everywhere it's hard to tell what's what. Even with experience and knowing what...Leave a comment:
-
Welcome to GreenHulk !
The blk/yel wire is the "kill" signal for the CDI to turn off. The switch on the handle bar simply switchs to ground to do that....Leave a comment:
-
The 2 styles of bilge plugs can be bought at Walmart. Only one size.
Both styles tighten to the hull to prevent falling out, just like on a boat.Leave a comment:
-
The MFI (digital gauge) is not a good tool for diagnosis.Way toooo Many times the voltage is wrong. It needs to be checked/double checked with an actual volt meter/multi-meter....Leave a comment:
-
My process is kinda specific and starts with cranking voltage on red/pur at CDI - double checking ground with that test.
My test checks a few parts that can keep...Leave a comment:
-
Thanks for sharring your experience, but the tripple carbs you have are a bit different from this single carb.
Yes there should be pressure in the tank, that is controlled...Leave a comment:
-
Have you tested the stator ? The tech section will have details for the test-turning engine by hand.
You should also test power at red/purple wire at CDI while...Leave a comment:
-
That is basically what is in there.Some models might have a dab of adhesive/epoxy to help hold it in place.But I might be remembering ride plate/intake grate inserts. Not sure...Leave a comment:
-
Welcome to GreenHulk.
The web page needs updating and maintenance. There is a thread discussing the issue.
Nearly everything is posted on this site somewhere....Leave a comment:
-
polaris# 2872860 - I didn't see anything priced reasonably. IIRC they were around $20 from the dealer.
A while back somebody tried this Seadoo float 295 500 438,...Leave a comment:
-
Are you good with electrical testing ?
There are a couple things that could keep the CDI from working. There are many threads with tests, also a test for what I think is...Leave a comment:
No activity results to display
Leave a comment: