Announcement
Collapse
No announcement yet.
User Profile
Collapse
-
If you have 12v IN to the main fuse but no power out.....either the fuse is bad OR there is an internal break in the wire that you can't see.
-
For a 2015 model.....it sure sounds like overall the ski has been neglected badly on proper maintenance and storage.
Leave a comment:
-
Not full of coolant unless it's real bad. Drain all the coolant, THEN put 20psi into the coolant side and use a mechanics stethoscope to listen in each plug hole. I've replaced...
Leave a comment:
-
Have you gone over the exhaust thoroughly? Maybe there's a small leak somewhere and the engine is ever so slightly choking on fumes?
Leave a comment:
-
Also does the inside have a gas fume smell after a ride? Seems like the top of the fuel pump module likes to crack on those. it starts out just like that, then gets worse to the...
Leave a comment:
-
When you push the start button, you should get a 12v signal to the plug on the stafrter solenoid. Do you have a 12v signal?
Leave a comment:
-
The safest way is to use little wire brushes to scrape off all the flaking paint you can reach. Then mix up a 1:1 mixture of white vinegar and water and scrub those areas with...
Leave a comment:
-
OK, start with the solenoid. Should have 12v on red from battery. Should also be a small red wire on that same side.....trace that one to the problem.
Leave a comment:
-
-
Sorry, need to check red or brown to ground. I can't remember offhand which is supply but I think it's red. Then when you push starter button the 12v returns on brown. So, check...
Leave a comment:
-
-
Throw a fresh coat of paint on it and go register it as a "homemade". That's how they do it 'round here.
Leave a comment:
-
Lets see a pic of the ski and the connector you're talking about.
Leave a comment:
-
Did somebody change something? All of a sudden this morning it seems to go back only one page as it should.
Leave a comment:
-
Looks like you have a 951. You'll need to remove the exhaust pipe. Unbolt the oil pump and lay it aside. Unplug the stator connector. Unbolt the front engine mount. Shove a block...
- Likes 1
Leave a comment:
-
Why is page back not working right?
If I go to my subscriptions or recent posts, I like to look through things and go back to the list if a certain post doesn't interest me. On this updated site, the page back kicks...
-
Rev is the RPM's.....same thing. If it sounds like it's building full power but the jet ski just feels sluggish and does not go full speed I would look first at a pump seal kit....
Leave a comment:
-
-
OK, if the start button is good.......have you checked for an actual 12 volts on the red or brown wires?
Leave a comment:
-
OK, if the start button is good.......have you checked for an actual 12 volts on the red or brown wires?
Leave a comment:
No activity results to display
Show More
Leave a comment: