bizeagle
Last Activity: 03-30-2023, 10:40 AM
Joined: 02-19-2016
Location: Georgia
-
Also, when you jack up the ski, you probably need to put 4 jack stands with 2x4s on either side of the floor jack to hold the weight for several days. Floor jacks can some times... -
I used Speedcoat-49, similar to Gator Glide. You can apply it with a fine knap mini roller. Try lifting the ski off the bunks with a floor jack on the ride plate. Cover the...Leave a comment:
-
That pic shows a crazy amount of peeling, almost like a defective original base under the paint. Frequent beaching would not look like that, would it?Leave a comment:
-
One of my ski's is Nano with 230 hours and the hull looks great. Hard to believe that one has only 71 hours and it peeled like that....Leave a comment:
-
looks like it would be easier to insert the drive shaft & new impeller with the ride plate removed. So I will try it with the drive plate loosened. I’ll remove it if I...Leave a comment:
-
I was at my dealer yesterday. He had a good number of new Yamaha's and Seadoos on the display floor but he said most of the ones on the floor are already sold. He is concerned...Leave a comment:
-
Question about the Speed Sensor cable, is this 1 continuous cable from the sensor all the way to the circuit board? Or is there a connector inside this of this PVC nut, so you...
Leave a comment:
-
Well, I did not "slather it up good" with anti-seize, but I did put a thin coat on the surface where the impeller contacts the washer and tightened it to 240 ft lbs....Leave a comment:
-
Seriously, when ordering PWC parts, accessories, there's not a better source than GreenHulk. Any price discount from Amazon is not worth the difference. Been ordering on GreenHulk...Leave a comment:
-
Got my new impeller today. Shipping was fast. Thanks GreenHulk...Leave a comment:
No activity results to display
Leave a comment: