JCIBELLA
Last Activity: 06-03-2023, 05:15 PM
Joined: 09-03-2017
Location:
-
You forgot the most important one AFR. How is it adjusted. That what we want to know!! -
That is a GFR TURBO KIT. The up & down pipes & turbo are water jacketed. The TURBO is a Garrett G25-660. This is a 2022 RXT. I'm have the motor buit with CP pistons, Carrillo...Leave a comment:
-
Engine builder
Looking for someone to finish my 2022 300 motor with 10 hour on it. I sent the motor out Feb 13 2033 with all the parts less the gaskets. I still haven't received the motor. The... -
Need 300 engine rebuilt
Looking for someone to finish my 300 engine build. I sent a 2022 300 with 10 hours on the motor and all the parts pistons, rods, valves, springs, retainers, valve guides, ported... -
I installed my turbo much lower & further back. It sits just below hull. Not much extra clearance for the seat.Leave a comment:
-
Leave a comment:
-
I was looking at your intake and position of the turbo. Will the seat still fit??Leave a comment:
-
300 Engine Builder recommended
Try to get my 2022 300 motor built. Needs sleeves installed & 1mm oversized valves & guides installed. I sent CP pistons, Carrillo rods, Supertech valves springs retainer,... -
Breaker bar 1/2" with a piece of pipe to extend length. A good vice. Then lots of ass.Leave a comment:
-
Supertech standard spring pressure....Leave a comment:
-
Valve Spring Spacer
I have a built 300 motor. It has Supertech Springs & 1mm oversized valves & Calas cam CP pistons & Carillo Rods. This is a Turbo build. I'm being told to install .030...
No activity results to display
Leave a comment: